(Part One)
During the use of the melter, daily maintenance and inspection can not only eliminate and find faults, but also better maintain the equipment and extend the service life of the machine.
DAILY CHECK LIST
Heating
Confirm that the device is turned on and heated. There are three ways to start heating:
(1) Timer
(2) Remote host control
(3) Manual switch
Heating may take about 40 to 60 minutes
Initial inspection
- as required
Necessary conditions: wear safety protective equipment
Once the problem is found:
→ Report to supervisor or maintenance personnel
- Compressed air
Check air supply
- Leak
Check the diverter valve for leaks:
→ Check for new hot leak adhesive
Check if the screw connection is tight
Check if the filter screws are tight
Check whether the pressure relief valve is locked
- Leak
Check the spray gun for leaks:
Check if the screw connection is tight
- Air leakage
Check the spray gun for air leaks:
View tracheal connection
Listen for leaking noise
- Check the cable
View cable and plug connections:
Check gun cable connection
→ Is it installed correctly
- Trigger
Check the nozzle part:
Check the nozzle for new hot melt adhesive
→ Trigger
Check for flying wires
- Cable connection plug
View cable connection plug
Throat and spray gun connection plug
- Cable connection plug
Check cable connection plugs and connectors
Located at the back of the machine
- Cable connection plug
Check the pump body connection plug
Located at the back of the machine
Now It’s your turn
I hoped you enjoyed my detailed information for starting a business.
Now I want to hear from you:
Which parts from this post are you most excited to know ?
Are you going to know more other kinds of related products? Or do you want to do deep research on this line?
Let me know by leaving a quick comment.