Daily inspection items of melter

Spread the love

During the use of the melter, daily maintenance and inspection can not only eliminate and find faults, but also better maintain the equipment and extend the service life of the machine.

 

 

Filling adhesive

 

  1. Necessary conditions: adhesive, feeding container

Open the lid of the melting cylinder and check the liquid level in the cylinder

→ Keep the liquid level not too low

Filling

→Add material to 5cm below the melting cylinder head

→Note: Don’t overfill it!

 

  1. After feeding

After feeding:

Tighten the lid

Open the lid and clean the top

Throw the fallen glue into the trash can

 

Ready to check

 

  1. Check if the Ready indicator is on

Reasons for the Ready indicator not to light:

  1. a) It is still in the heating stage
  2. b) The pump body is not working

 

  1. Check whether the pump body is pressurized

prompt:

If a pressure regulator is installed, the pressure gauge will be 0 when not pressurized.

 

Test run

 

Production pre-test:

Start the production line

Trial-produce a small amount of products and stop

 

Glued products

Is the amount of glue correct

Is the location correct

Compared with reference product

 

Start production

 

Start the production machine

 

Produce

 

  1. Regularly check the final product

Regular inspection of glued products

 

Check bonding

→Finally open product inspection

Check if the glue amount is correct

Check if the location is correct

 

  1. Add adhesive

Regularly check the liquid level of the melt tank

The time interval depends on the production speed

Open the lid of the melting tank and check the liquid level

Tip: → Keep the liquid level not too low

When the liquid level sensor is installed, the liquid level status A50 and the low liquid level indicator will be displayed when the set low liquid level is reached. In addition, warning lights can also be installed.

 

End of production

 

  1. a) Keep daily clean
  2. b) Make sure the hot melt machine is turned off

 

Now It’s your turn

I hoped you enjoyed my detailed information for starting a business.

Now I want to hear from you:

Which parts from this post are you most excited to know ?

Are you going to know more other kinds of related products? Or do you want to do deep research on this line?

Let me know by leaving a quick comment.

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *