During the use of the melter, daily maintenance and inspection can not only eliminate and find faults, but also better maintain the equipment and extend the service life of the machine. Daily cleaning Consumables -Lint-free cotton -*Citrus milk cleaning agent P/N 148737 *Do not use Citrus milk detergent in the food industry. Clean the top of the working melting tank Use cleaning agent to clean the melt cylinder head Clean the outside of working equipment Use detergent to clean the outside of the equipment Clean the working spray gun and the outside of the nozzle Clean the nozzle part: Use a lint-free cotton cloth to clean the nozzle → from outside Clean the bottom of the equipment spray gun Clean the nozzle Check if there is flying wire …
Continue Readinginspection items
Daily inspection items of melter
During the use of the melter, daily maintenance and inspection can not only eliminate and find faults, but also better maintain the equipment and extend the service life of the machine. Filling adhesive Necessary conditions: adhesive, feeding container Open the lid of the melting cylinder and check the liquid level in the cylinder → Keep the liquid level not too low Filling →Add material to 5cm below the melting cylinder head →Note: Don’t overfill it! After feeding After feeding: Tighten the lid Open the lid and clean the top Throw the fallen glue into the trash can Ready to check Check if the Ready indicator is on Reasons for the Ready indicator not to light: a) It is still in the heating stage b) The pump body is not working …
Continue ReadingDaily inspection items of melter
(Part One) During the use of the melter, daily maintenance and inspection can not only eliminate and find faults, but also better maintain the equipment and extend the service life of the machine. DAILY CHECK LIST Heating Confirm that the device is turned on and heated. There are three ways to start heating: (1) Timer (2) Remote host control (3) Manual switch Heating may take about 40 to 60 minutes Initial inspection as required Necessary conditions: wear safety protective equipment Once the problem is found: → Report to supervisor or maintenance personnel Compressed air Check air supply Leak Check the diverter valve for leaks: → Check for new hot leak adhesive Check if the screw connection is tight Check if the filter screws are tight Check whether the pressure relief valve is…
Continue Reading